RTA 460ETCMRS Guide de l'utilisateur télécharger pdf (Page 16)

1. For additional PLC’s, click the Add PLC button and follow instructions under Manual Mode for

each additional device.

-Auto-Server Mode only affects PLC 1.

2. The Enable check box should be selected for the device.

3. Enter a Device Label to identify the device within the gateway.

4. Enter the IP Address of the PLC, the Controller Slot (Integrated Ethernet, use Slot 0), and select

the PLC Type. The Controller Slot is the slot where the Controller is located, not the Ethernet

Card being used. These 3 parameters must match the PLC you are communicating to.

5. Select the Comms Mode. Unconnected (UCMM) messaging relies on shared resources to

transfer data to/from the PLC. This could result in message timeouts if there are a lot of devices

fighting for these shared buffers. Connected (Class 3 Explicit) messaging relies on reserved

resources to transfer data to/from the PLC. RTA recommends using Connected.

6. To edit scan lines, you will need to go into Manual Mode.

Real Time Automation, Inc. 16 1-800-249-1612

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 55 56

Pas de commentaire

RTA 460ETCMRS Guide de l'utilisateur Page 16